section bending machine

Profile bending machine
Angle & Section Bending Machine
Manufacturer

Home >> Profile Bending Machine >> Section Bending Information >> Installation and commissioning of hydraulic angle bender machine

Installation and commissioning of hydraulic angle bender machine

Installation and commissioning of hydraulic angle bender machine

Installing

We packed the angle bender machine as a whole in steel carton. When arriving in client’s part, please check the correspondence of packing list and real machine. Before debugging, please inject oil to machine.

Debugging

Preparation before debugging

Please check all connected and clamping parts.

Please check the angle bender hydraulic oil level, and check if the lubrication is okay.

Please check the voltage of electricity.

Angle bender installation and commissioning

Run without loading

After check above all, please run the main drive and do up and down movements, take 15 minutes as a cycle.

Check the and adjust the up roller and sides rollers, to make the distance is suitable and workable.

test requirements

Movements should be smooth on both sides of roll

Roller rotation and lift should be flexible

All Transmission Parts should be no abnormal noise

All fasteners are not allowed loose, well-oiled machine

Bearing temperature should not exceed exceed 35 °C, the highest temperature should not exceed 70 ° C, bearing the temperature should not exceed 40 ° C, the highest temperature should not exceed 70 ° C, the hydraulic pump oil temperature should not exceed 60 °C .

Load test

No-load test to normal only after the load test. The general procedure is as follows:

Basic parameters in the table according to the provisions of the relevant profile parameters expected, pre-bend sections of treated end.

On an operational proficiency scores of sub-volumes into the provisions of the diameter of round workpieces.

Load test requirements

Load testing should meet the basic parameters of the relevant performance requirements.

The load and load operation process, the transmission system should be stable, the impact of no abnormal noise, working system, the operating system should be flexible, accurate and reliable, the bearing temperature must not exceed the above requirements.

The process of rolling the die and the profiles there is no slipping between the phenomenon.