Particular attention should be paid to the angle bending of unequal leg angles. You must specify short leg in, short leg out, long leg in, long leg out. Otherwise the radius or diameter of such rolled angles is usually specified as measured just as the corresponding equal leg angles.
Angles are often used in tank stiffeners, matching flanges, curved lintels, hand rails, lagging rings, form work and fabricated roof trusses.
Depending upon your unique project requirements, Profile Bending angle bending may be performed on a variety of materials, including carbon steel, stainless steel, aluminum, titanium, and copper.
Can also bend all types of angle as well; including aluminum, stainless and carbon steel. Carbon angle (mill produced) is classified as ASTM A36 resulting in a yield point (PSI) of 36,000 minimum.
Rolled angle bending is a cost-effective process that eliminates sharp edges, improves strength, angle rolling delivers functional and cosmetic value for many applications.
BIT section bending machine’s Bending angle bending may be performed on a variety of materials, including carbon steel, stainless steel, aluminum, titanium, and copper to make curves, angle iron rings, angle iron flanges, angle iron pipe supports, and many other parts.
Safety Safe systems of work should be followed when operating a profile bending machine. In particular: The use of gloves with fingertips during initial feeding of work pieces should be prohibited because the tips can be caught and drawn into the roll intake. Where there is a genuine need for hand protection, palm protection only […]
When bending about angle iron rolled leg out, angle rolled leg in should be specified by the OD of the ring for most cases since there are two ID’s of the ring; the ID of the easy way leg and the ID of the hard way leg. If the ID of the hardway leg Is […]